Triton FetHead Broadcast Manual

Triton Not categorized FetHead Broadcast

Read below đź“– the manual in Italian for Triton FetHead Broadcast (2 pages) in the Not categorized category. This guide has been helpful for 5 people and has been rated 4.5 stars on average by 2 users

Page 1/2
FetHead Broadcast
Philosophy
FetHead Broadcast -is an in line microphone preamplifier specially designed for operating in challenging live
environments. FetHead Broadcast offers 23dB of low noise high quality amplification which can be applied
to either dynamic or condenser microphones as phantom power transferred to the microphone. is
Recommended application
In broadcast or live performance situations, a microphone signal often travels through long cables before
reaching the mixing desk. When small microphone signals travel adjacent to power lines or dimmed light
cables, audible signal interference is likely to be induced into the microphone cable. Fethead Broadcast
amplifies the microphone signal before the cable and greatly improves the signal to noise ratio offering a
much higher quality signal to the mixing desk. A low impedance output buffer enables output drive to long
cables (up to 3000 meters). Another advantage is that the FetHead Broadcast does not need main supplies
or batteries.
Operation
Connect your microphone on the input XLR of your Fethead Broadcast. At the opposite side an XLR cable
runs from your Fethead Broadcast to the mixer/preamp. it’s ready for use with any type of phantom
powered setup. Fethead Broadcast uses phantom power to power its circuitry, but also provides enough
phantom power to power the connected microphone.
Circuit topology
FetHead Broadcast utilizes a low noise FET amplifier circuit, which reveals every detail, followed by a low
impedance output buffer which reveals every detail with pinpoint accuracy and offers high-end sound
quality.
Features
• Low noise Class A FET amplifier
• Low impedance output buffer
• 23 dB amplification
• Rugged enclosure with balanced XLR input/output
• internal rumble filter
• frequency response 40Hz-100 kHz (+/- 1dB)
• Z- in 680 Ω
• Circuit is powered with 48V phantom power
Dimensions
height: 1,22” / 31mm
width: 1” / 26mm
length: 3,11” / 79mm
weight: 80 g
Registration
Thank you for purchasing a Triton Audio Fethead Broadcast. To register your product please go to:
www.tritonaudio.com/support#registration

Product Specifications

Brand: Triton
Category: Not categorized
Model: FetHead Broadcast

Do you need help?

If you need help with Triton FetHead Broadcast, ask a question below and other users will answer you




Not categorized Triton User Manuals

Not categorized User Manuals

Latest Not categorized User Manuals