DPA 4017ES Manual

DPA Microphone 4017ES

Read below šŸ“– the manual in Italian for DPA 4017ES (2 pages) in the Microphone category. This guide has been helpful for 6 people and has been rated 4.5 stars on average by 2 users

Page 1/2
d:dicateā„¢ 4017ER Shotgun Microphone, Rear cable
d:dicateā„¢ 4017ES Shotgun Microphone, Side cable
A combination of the MMC4017 Microphone Capsule and the
MMP-E modular active cable, this mic is part of the modular d:dicateā„¢
Recording Microphone series.
Suspension mount
Suspend the mic in the mount by securing the hook around the notch
on the preamp. Subsequently twist the cable in the spiral-shaped end
of the mount. This allows the Microphone to hang in its own cable and
be adjusted to any direction by bending the boom.
With each d:dicateā„¢ Microphone Capsule, comes a unique calibration
chart that shows the exact frequency response of the purchased
Capsule measured with a linear MMP-A Preampliļ¬er.
Typical on- and oī˜ž-axis frequency responses for a MMC4017 at 30
cm (1 ft):
d p a m i c r o p h o n e s . c o m / 4 0 1 7 E
Service & repair
If you are not satisļ¬ed with the characteristics exhibited by this product, please go to
www.dpamicrophones.com/service for instructions.
Warranty
The d:dicateā„¢ 4017ER-4017ES Shotgun Microphone, is covered by a ļ¬ve-year limited warranty.
CE marking
This product conforms to all relevant directives approved by the European Commision.
DPI-4017E-QG
dB
10
0
-10
-20
-30
20 Hz 50 100 200 500 1 kHz 2 5 10 20 40
0
30
60
90
Speciļ¬cations
Directional pattern
Supercardioid, lobe-shaped
Principle of operation
Pressure gradient, with interference tube
Cartridge type
Pre-polarized condenser
Frequency range
20 Hz - 20 kHz
Frequency range, Ā±2 dB, at 30 cm
40 Hz - 18 kHz with typ. 3 dB soft boost at 15 kHz
Sensitivity, nominal, Ā±2 dB at 1 kHz
19 mV/Pa; -34.4 dB re. 1 V/Pa
Epuivalent noise level, A-weighted
Typ. 13 dB(A) re. 20 ĀµPa (max. 15 dB(A))
Max. SPL, peak before clipping
142 dB
Output impedance
100 ā„¦
Minimum load impedance
2 kā„¦
Cable drive capability
100 m (328 ft)
Output balance principle
Signal balanced
Common Mode Rejection Ratio (CMRR)
> 40 dB
Power supply
48 V Phantom power (Ā±4 V)
Current consumption
3.5 mAe
Connector
XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Weight
109 g (3.8 oz)
Polarity
+V at Pin 2 for positive sound pressure
Operating temperature range
-40 to 45Ā°C (-40 to 113Ā°F)
Relative humidity
Up to 90%

Product Specifications

Brand: DPA
Category: Microphone
Model: 4017ES

Do you need help?

If you need help with DPA 4017ES, ask a question below and other users will answer you




Microphone DPA User Manuals

DPA

DPA d:fine CORE 4188 Manual

15 October 2024
DPA

DPA d:dicate 4018C Manual

15 October 2024
DPA

DPA 4017ES Manual

14 October 2024
DPA

DPA 4017B Manual

14 October 2024
DPA

DPA 4017C Manual

14 October 2024

Microphone User Manuals

Latest Microphone User Manuals

DAP Audio

DAP Audio EDGE EUA-1 Manual

27 October 2024
DAP Audio

DAP Audio EDGE ED-1 Manual

27 October 2024
DAP Audio

DAP Audio PL-07 Manual

27 October 2024
DAP Audio

DAP Audio BP-10 Manual

27 October 2024
DAP Audio

DAP Audio EDGE EBS-2 Manual

27 October 2024
DAP Audio

DAP Audio EDGE EOA-1 Manual

27 October 2024
DAP Audio

DAP Audio HM-30 Manual

27 October 2024
DAP Audio

DAP Audio EDGE EHS-2 Manual

27 October 2024
DAP Audio

DAP Audio EDGE EBT-1 Manual

27 October 2024
DAP Audio

DAP Audio CM-87 Manual

27 October 2024