Pioneer CA-BC-DAI.001 Manual

Pioneer Not categorized CA-BC-DAI.001

Read below đź“– the manual in Italian for Pioneer CA-BC-DAI.001 (2 pages) in the Not categorized category. This guide has been helpful for 3 people and has been rated 4.5 stars on average by 2 users

Page 1/2
Image Sensor: 1/3” CCD
Resolution: NTSC 510 x 492, PAL 500 x 582
TV Lines: 580
Lens: 1.7mm
Minimum Illumination: 0 Lux (LED’s on)
Infra-Red LED’s: Yes
Night Vision Distance: 35ft
Waterproof Rating: IP68
Viewing Angle: 170 Degrees
Image: Mirror
Operating Voltage: 12V DC (Negative Ground)
Current Consumption: 77-125mA @ 13.8V
Operating Temperature: -20 Degrees C to +70 Degrees C
U s e r M a n u a l
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any tech-
nical issues. With this in mind, when contacting Connects2, try to provide as much Infor-
mation as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Iveco Reverse Camera
Iveco Daily 2014>
PRODUCT FEATURES:
DISCLAIMER:
CAM-IV2
www.connects2.com
2
Connects2Vision
CONTENTS
- Camera with 70cm cable to Male 4pin camera connector
- 10m 4pin to 4pin extension cable
- Camera connection cable with Female 4pin camera connector, 2x RCA Female
connectors and Female DC connector
- 1.45 DC power cable with Male DC connector
- Male to Male RCA splice
- Instructions
INSTALLATION
1. Remove the third brake light housing from the vehicle and remove the brake light
assembly and courtesy lamp.
2. Attach the brake light assembly and courtesy lamp to the CAM-IV2 and ret to
the vehicle taking care not to trap any cables.
3. Connect the Black wire to a suitable ground and connect the Red wire to the
reversing light circuit or an interface which provides a reverse signal.
4. Connect the camera to the 4pin extension cable, connect the extension cable
to the camera connection cable and connect the camera connection cable to
the display screen via the Yellow RCA connector and supplied RCA splice and en-
sure that the image is displayed correctly.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2

Product Specifications

Brand: Pioneer
Category: Not categorized
Model: CA-BC-DAI.001

Do you need help?

If you need help with Pioneer CA-BC-DAI.001, ask a question below and other users will answer you




Not categorized Pioneer User Manuals

Not categorized User Manuals

Latest Not categorized User Manuals