Lectrosonics DNTBOB88 Manual
Lectrosonics
Processor
DNTBOB88
Read below š the manual in Italian for Lectrosonics DNTBOB88 (16 pages) in the Processor category. This guide has been helpful for 4 people and has been rated 4.5 stars on average by 2 users
Page 1/16
DNTBOB 88
8x8 Breakout Box
INSTALLATION AND SETUP GUIDE
Rio Rancho, NM, USA
www.lectrosonics.com
Fill in for your records:
Serial Number:
Purchase Date:
Dante is a trademark of Audinate Pty Ltd.
IMPORTANT:
Set all DNTBOB 88 units to the
Switched mode for initial setup.
See page 7 for details.
DNTBOB88
Tested to comply
with FCC Standards
FOR HOME OR OFFICE USE
ASPEN Digital Processor
LECTROSONICS, INC.
2
FCC Part 15 Compliance
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired op-
eration.
CAUTION: Changes or modiļ¬cations not expressly
approved by Lectrosonics, Inc. could void the userās
authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. The
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
ā¢ Reorient or relocate the receiving antenna
ā¢ Increase the separation between the equipment
and receiver
ā¢ Connect the equipment into an outlet on a circuit
different from that which the receiver is connected
ā¢ Consult the dealer or an experienced radio/TV
technician for help
Changes or modiļ¬cations to this equipment not ex-
pressly approved by Lectrosonics, Inc. could void the
userās authority to operate it.
Industry Canada
Compliance
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numƩrique de la classe B est conforme a
la norme NMB-003 du Canada.
Installation and Quick Start Guide
Rio Rancho, NM 3
This symbol, wherever it appears, alerts
you to the presence of uninsulated danger-
ous voltage inside the enclosure -- voltage
that may be sufļ¬cient to constitute a risk of
shock.
This symbol, wherever it appears, alerts
you to important operating and mainte-
nance instructions in the accompanying
literature. Please read the manual.
When using your telephone equipment, basic safety
precautions should always be followed to reduce the
risk of ļ¬re, electrick shock and injury to persons, includ-
ing the following:
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with a dry cloth.
7) Do not block any ventilation openings. Install in ac-
cordance with the manufacturerās instructions.
8) Do not install near any heat sources such as radia-
tors, heat registers, stoves, or other apparatus
(including ampliļ¬ers) that produce heat.
9) Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and third grounding prong.
The wider blade or the third prong are provided
for your safety. If the provided plug does not ļ¬t into
your outlet, consult an electrician for replacement of
the obsolete outlet.
10) Protect the power cord from being walked on or
pinched particularly at plugs, convenience recepta-
cles, and the point where they exit from the appara-
tus.
11) Only use attachments/accessories speciļ¬ed by the
manufacturer.
12) Use only with the cart, stand, tri-
pod, bracket, or table speciļ¬ed by
the manufacturer, or sold with the
apparatus. When a cart is used,
use caution when moving the cart/
apparatus combination to avoid
injury from tip-over.
13) Unplug this apparatus during lightning storms or
when unused for long periods of time.
Important Safety Instructions
14) Refer all servicing to qualiļ¬ed service personnel.
Servicing is required when the apparatus has
been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
15) WARNING -- TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
16) The AC mains plug, or appliance coupler shall be
readily available to the operator as a means of
power disconnection, if applicable.
17) Unit shall be connected to a MAINS socket outlet
with a protective earthing connection.
18) Do not use this product near water for example,
near a bathtub, washbowl, kitchen sink or laundry
tub, in a wet basement or near a swimming pool.
19) Avoid using a telephone (other than a cordless
type) during an electrical storm. There may be a
remote risk of electric shock from lightning.
20) Do not use the telephone to report a gas leak in
the vicinity of the leak.
21) Use only the power cord and batteries indicated
in this manual. Do not dispose of batteries in a
ļ¬re. They may explode. Check with local codes for
possible special disposal instructions.
22) āCAUTION: To reduce the risk of ļ¬re, use only No.
26 AWG or larger (e.g., 24 AWG) UL Listed or
CSA Certiļ¬ed Telecommunication Line Cordā
SAVE THESE INSTRUCTIONS
Product Specifications
| Brand: | Lectrosonics |
| Category: | Processor |
| Model: | DNTBOB88 |
Do you need help?
If you need help with Lectrosonics DNTBOB88, ask a question below and other users will answer you
Processor Lectrosonics User Manuals
17 October 2024
17 October 2024
13 October 2024
Processor User Manuals
- Processor Bose
- Processor Henry Engineering
- Processor Helix
- Processor SPL
- Processor Black And Decker
- Processor Radial Engineering
- Processor MyMix
- Processor Atlas Sound
- Processor Allen & Heath
- Processor Ashly
- Processor MuxLab
- Processor TC Helicon
- Processor Bogen
- Processor Sonifex
- Processor BSS Audio
- Processor Drawmer
- Processor Dangerous Music
- Processor Neutrik
Latest Processor User Manuals
17 October 2024
17 October 2024
17 October 2024
17 October 2024
17 October 2024
16 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024