Bazooka BPB36-G2 Manual
Read below 📖 the manual in Italian for Bazooka BPB36-G2 (2 pages) in the Speaker category. This guide has been helpful for 8 people and has been rated 4.5 stars on average by 2 users
Page 1/2
1.
3 .
4. 5. 6. 7. 8. 9. 10.
11.
12.
2.
Remove fuse from 6 ft power cable (12). Attach the red wire to the positive battery terminal. Attach the black wire
to the negative battery terminal. Run power cable to the location of the BPB24. making sure power wire does not
hinder the safe operation of the vehicle. Plug the red power cable end into the BPB24’s red input power plug. The
black 12vdc accessory plug can be used to power any 12vdc accessory up to 15 amps. Use the included black
accessory pigtail (11) to wire your accessories.
1. Party Bar (BPB24, BPB24-DS, or BPB36) 1 ea.
2. Optional Mounting Bolt 6mm 4 ea.
3. Mounting Leg 2 ea.
4. Rubber Vibration Insulation Pads 2 ea.
5. Socket Head Cap Screw 8mm X 12mm 2 ea.
6. Low Profile Socket Head Cap Screw 6mm X 12mm 2 ea.
7. Socket Head Cap Screw 6mm X 30mm 2 ea.
8. Narrow Washer 6mm 4 ea.
9. Nylon Insert Locking Nut 6mm 2 ea.
10. Stud 6mm x 40mm 2 ea.
11. Accessory Pigtail 1 ea.
12. Power Cable 6 ft. 1 ea.
IMPORTANT NOTICE:
The internal RF circuit for the remote control will draw a small amount of current because it must always be ON
listening for the remote commands. Over time this could draw down your battery when your machine remains in
storage without being connected to a charger or not being actively used. For this reason, we recommend
connecting the Party Bar to a switched master power source or disconnecting the main power wire when the
machine is in storage. We also make a plug & play inline 12v master power switch that can be easily added to the
main battery wire for the Party Bar to completely kill power to the unit. It is listed under the Accessories tab on the
Party Bar product page on our website (Model number: PR-ILS16)
When using the Intergrated Mounting Rail System,
first determine your mounting stud spacing then screw
the 6mm X 40mm studs (10) into the mounting nuts. Mark
your desired spacing onto the flat surface to which you are
mounting. Use a 1/4” or 7mm drill bit to drill mounting holes.
Mount the Party Bar to your mounting surface using the 6mm
washers (8) and 6mm nylon locking nuts (9) provided in
hardware kit. You can also use our optional PR-URM, PR-FRC175,
and PR-FRC200 clamps (sold separately) to mount to round
tubbing. When mounting the bottom half of the clamps to
the Party Bar, you will need to use the 2 ea. 6mm X 12mm low
profile socket head cap screws. (6)
Use the 8mm X 12mm bolts (5) to attach
the mounting legs. Mounting legs (3) can
be installed in ether direction depending
on space constraints. When mounting with
opional clamps (PR-URM, PR-FRC200, and
PR-FRC175) use the hex bolts provided with
the clamps to mount the bottom half of the
clamps to the mounting legs.
PR-FRC200 2” Clamp
PR-FRC175 1.75” Clamp PR-URM 2” - 1.5” Clamp
Warning:
If you are using the cast aluminum mounting legs to secure the Party Bar to your machine, the mounting legs must
FIRST be attached and tightened to the Party Bar before mounting it to your machine. Attaching the legs to the
machine first and then inserting the Party Bar between them can cause misalignment, spacing, and torque issues
that can cause damage to the mounting assembly resulting in a failure.
Intergrated Mounting Rail Options
See Warning Below!
End Mounting Options
with Cast Aluminum Legs
BPB24 / BPB24-DS
BPB36
Installation Instructions
Rev.12/12/2016 Pg. 1
Rev.12/12/2016 Pg. 4
BPB24 / BPB24-DS
BPB36
Installation Instructions
PR-FRC200 2” Clamp
PR-FRC175 1.75” Clamp
PR-URM 2” - 1.5” Clamp
Aux Input Audio Output
Rev. 12/12/2016 Pg. 3
Rev.12/12/2016 Pg. 2
Button 1
Auxiliary 12vdc output on/off switch.
Button 2 Press and hold to power on, press while power is on to switch input
between aux. and Bluetooth inputs, Press and hold to power off.
Button 3 Press to go forward one track, Press and hold to increase volume.
Button 4
Button 5 Press to go back one track, Press and hold to decrease volume.
Aux. Input Used for a 1/8” audio cable
Aud io Output Used for line level audio signal to an amplifier
Press to play/pause, Press to answer/hang up phone, Double
press for last number radial or open Siri on Iphone, Press and
hold to unpair bluetooth device.
Bluetooth module audio indicators:
Audio Response
Power on:
Power off:
Beep:
Beep:
Double Beep:
Module is turned on
Module is turned off
After LED light stops blinking means module is paired
When play/pause button is pressed and held means
module is unpaired from Bluetooth device.
When forward button is pressed and held means
module has reached maximum volume.
Description
Switch 1 On/Off
Remote switch buttons 2-4 are not used with this model
Switch aux. 12vdc (15 amp) ouput.
LED light status indicator:
LED Light Description
Blinking: Bluetooth module is pairing
Solid blue: Bluetooth module is paired
Blue/Red: Bluetooth module is in AUX
input mode
Led Mic.
Note: * When pressing for Power Off, be sure to hold until Power Off is indicated (audible). Failure to do so
may toggle the Bluetooth Receiver into AUX/BT Mode and it will remain in the last selected mode on subsequent Power On.
If this occurs, simply press the M button again to reselect BT or AUX mode as desired. The receiver should automatically pair
with the last device in BT mode. To pair a new device, press and hold the Play/Pause button.
BPB24 / BPB24-DS
BPB36
Installation Instructions
BPB24 / BPB24-DS
BPB36
Installation Instructions
Product Specifications
| Brand: | Bazooka |
| Category: | Speaker |
| Model: | BPB36-G2 |
Do you need help?
If you need help with Bazooka BPB36-G2, ask a question below and other users will answer you
Speaker Bazooka User Manuals
24 October 2024
24 October 2024
14 October 2024
14 October 2024
14 October 2024
Speaker User Manuals
- Speaker Sony
- Speaker Xiaomi
- Speaker LG
- Speaker Bosch
- Speaker IKEA
- Speaker HP
- Speaker Philips
- Speaker Panasonic
- Speaker Hama
- Speaker Vorago
- Speaker Jensen
- Speaker Avantree
- Speaker Edifier
- Speaker Reflexion
- Speaker Meridian
- Speaker Teufel
- Speaker Kogan
- Speaker Soundcore
- Speaker Turbosound
- Speaker GoGEN
- Speaker Pro-Ject
- Speaker Yamaha
- Speaker Morel
- Speaker Axis
- Speaker Extron
- Speaker Media-tech
- Speaker Pioneer
- Speaker EarFun
- Speaker Ecler
- Speaker Audac
- Speaker Woxter
- Speaker KEF
- Speaker Audio-Technica
- Speaker Toa
- Speaker Metra
- Speaker Pyle
- Speaker Sencor
- Speaker Bose
- Speaker Orava
- Speaker Grundig
- Speaker JVC
- Speaker Kicker
- Speaker Auna
- Speaker Midland
- Speaker OSD Audio
- Speaker Power Dynamics
- Speaker Fenton
- Speaker Vonyx
- Speaker Bluesound
- Speaker Hertz
- Speaker Kenwood
- Speaker MB Quart
- Speaker Bigben
- Speaker Aplic
- Speaker CSL
- Speaker Bearware
- Speaker NUVO
- Speaker Maginon
- Speaker Infiniton
- Speaker Roku
- Speaker GPO
- Speaker Advance
- Speaker Sonance
- Speaker AXESS
- Speaker Be Cool
- Speaker Artsound
- Speaker Denon
- Speaker Ion
- Speaker Marshall
- Speaker Yorkville
- Speaker V-Tac
- Speaker MyDJ
- Speaker Valcom
- Speaker Celly
- Speaker JBL
- Speaker Infinity
- Speaker Majority
- Speaker Nedis
- Speaker Sharp
- Speaker Helix
- Speaker Genesis
- Speaker Klipsch
- Speaker Worx
- Speaker Muse
- Speaker Ground Zero
- Speaker Karma
- Speaker Glemm
- Speaker Match
- Speaker Speed-Link
- Speaker Renkforce
- Speaker Definitive Technology
- Speaker QSC
- Speaker WHD
- Speaker Q Acoustics
- Speaker Karcher
- Speaker GoldenEar
- Speaker Pyramid
- Speaker FoneStar
- Speaker Trevi
- Speaker Monitor Audio
- Speaker Canton
- Speaker Fresh N Rebel
- Speaker Energy Sistem
- Speaker Bauhn
- Speaker PSB
- Speaker Vizio
- Speaker Polk
- Speaker ESX
- Speaker Omnitronic
- Speaker MEE Audio
- Speaker Monacor
- Speaker ModeCom
- Speaker Hercules
- Speaker Black Hydra
- Speaker Electro-Voice
- Speaker Wharfedale
- Speaker Boss
- Speaker Tannoy
- Speaker Mount-It!
- Speaker GMB Audio
- Speaker Mad Dog
- Speaker Ashly
- Speaker Memphis Audio
- Speaker Focal
- Speaker Alpine
- Speaker ATen
- Speaker Genelec
- Speaker Lamax
- Speaker NGS
- Speaker Aiaiai
- Speaker RCF
- Speaker SVS
- Speaker Aiwa
- Speaker N-Gear
- Speaker Atlas
- Speaker PowerBass
- Speaker Prime3
- Speaker Harman Kardon
- Speaker Lexibook
- Speaker Ibiza Sound
- Speaker Creative
- Speaker Aconatic
- Speaker DAP Audio
- Speaker REL Acoustics
- Speaker Sonus Faber
- Speaker Xcellon
- Speaker OWI
- Speaker Titanwolf
- Speaker Weather X
- Speaker HK Audio
- Speaker Phoenix Gold
- Speaker Krüger And Matz
- Speaker Indiana Line
- Speaker Blue Tees
- Speaker BASSBOSS
- Speaker Polsen
- Speaker Deaf Bonce
- Speaker Tangent
- Speaker FBT
- Speaker Transparent
- Speaker IHome
- Speaker Martin Logan
- Speaker Andover
- Speaker ILive
- Speaker Moonki
- Speaker BlueAnt
- Speaker HuddleCamHD
- Speaker X JUMP
- Speaker PulseAudio
- Speaker Urban Revolt
- Speaker Audison
- Speaker Boynq
- Speaker Dynaudio
- Speaker Clarity
- Speaker VIETA PRO
- Speaker Potter
- Speaker Sonoro
- Speaker Yamazen
- Speaker OTTO
- Speaker Soen
- Speaker Miller & Kreisel
- Speaker Qian
- Speaker Iriver
- Speaker Standard Horizon
- Speaker The Box
- Speaker August
Latest Speaker User Manuals
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024