Tado Starter Kit - Wireless Smart Thermostat V3 plus - Incl. Programmer with Hot Water Control Thermostaat Manual

Tado Thermostat Starter Kit - Wireless Smart Thermostat V3 plus - Incl. Programmer with Hot Water Control Thermostaat

Read below 📖 the manual in Italian for Tado Starter Kit - Wireless Smart Thermostat V3 plus - Incl. Programmer with Hot Water Control Thermostaat (8 pages) in the Thermostat category. This guide has been helpful for 6 people and has been rated 4.5 stars on average by 2 users

Download PDF

Page 1/8

Manual for Professional

Installers

DIY Installation

If you are not a professional installer, please download the tado˚ app. There you will find specific installation instructions.

This manual is meant exclusively for professional installers. It includes generic instructions to install the Wireless

Receiver (Programmer) and the Wireless Temperature Sensor.

For the Starter Kit - Wireless Smart Thermostat V3+

(Incl. Programmer with Hot Water Control)

Manual version 3.2

A. Remove the battery

protection strip.

B. Press the button for

3 sec to start pairing.

C. Pairing may take up

to 2 min.

D. The static icon below

indicates successful pairing.

If pairing fails (E0), make sure the distance between the devices is approximately 3 meters. Pair again by pressing the

button for 3 sec.

2. Pair the Wireless Temp. Sensor

1. Install the Internet Bridge

A. Connect the Internet Bridge to the router.

If no free USB port is available on the router, use the

included 5V power adapter.

B. Press and hold the pairing button until the pairing LED

starts blinking.

min

sec

Solid on

Blinking

Unfold to check:

Step 4: Wire the Wireless Receiver

Step 5: Pair the Wireless Receiver

Step 6: Configuration

Extra information: Wireless Receiver Symbols

Power supply, testing

mode & configuration

Connection with

other tado˚ devices

Device errors Heat request Hot water request

If there is a wired room thermostat installed in the zone that is intended to be controlled by the Wireless Receiver,

please decommission it by bridging the control wires and insulating the other wires with the included 2-terminal

connector blocks as shown in the images.

Once tado° is installed, the Wireless Receiver will be the only device that controls the heating system.

For Neutral and Earth, Insert only one wire per block, even though the block has more than one opening.

3. Replace the room thermostat

LIVE

(COM) NEUTRAL EARTH

SWITCHED

LIVE (NO)

Caution! Turn OFF the

power before wiring!

Product Specifications

Brand:	Tado
Category:	Thermostat
Model:	Starter Kit - Wireless Smart Thermostat V3 plus - Incl. Programmer with Hot Water Control Thermostaat

Do you need help?

If you need help with Tado Starter Kit - Wireless Smart Thermostat V3 plus - Incl. Programmer with Hot Water Control Thermostaat, ask a question below and other users will answer you

Your Name*

Your Email*

Write your question here