Renkforce FT007TH Manual

Read below 📖 the manual in Italian for Renkforce FT007TH (6 pages) in the Weather station category. This guide has been helpful for 10 people and has been rated 4.5 stars on average by 2 users

Page 1/6
FT007TH Thermo-Hygrometer Sensor
User Manual
1 Introduction
Thank you for your purchase of the FT007TH Thermo-Hygrometer Sensor. The following user guide
provides step by step instructions for installation, operation and troubleshooting.
2. Thermo-Hygrometer Sensor.
1. Remove the battery door on the back of the sensor by removing the set screw, as shown in
Figure 1 .
Figure 1
2. inserting the batteries, locate the dip switches on the inside cover of the lid of the BEFORE
transmitter.
Figure 2 displays all four switches in the OFF position (factory default setting).
Figure 2
3. The FT007TH supports up to eight Channels. To set each channel number Channel Number:
(the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1.
4. Temperature Units of Measure: To change the transmitter display units of measure (°F
vs. °C), change Dip Switch 4, as referenced in Table 1.
DIP SWITCH FUNCTION
1 2 3 4
DOWN
DOWN
DOWN
---
Channel 1
DOWN
DOWN
UP
---
Channel 2
DOWN
UP
DOWN
---
Channel 3
DOWN
UP
UP
---
Channel 4
UP
DOWN
DOWN
---
Channel 5
UP
DOWN
UP
---
Channel 6
UP
UP
DOWN
---
Channel 7
UP
UP
UP
---
Channel 8
---
---
DOWN
---
---
UP
°C
Table 1
5. Insert two AAA batteries.
6. After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and
then flash once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting data.
7. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are on
the display, as shown in Figure 3.
Figure 3
(1) temperature
(2) temperature units ( °F vs. °C)
(3) channel number

Product Specifications

Brand: Renkforce
Category: Weather station
Model: FT007TH

Do you need help?

If you need help with Renkforce FT007TH, ask a question below and other users will answer you