Monogram ZV855SPS Manual

Monogram Extractor hood ZV855SPS

Read below 📖 the manual in Italian for Monogram ZV855SPS (22 pages) in the Extractor hood category. This guide has been helpful for 11 people and has been rated 4.5 stars on average by 2 users

Download PDF

Page 1/22

Installation

Instructions

Island Vent Hood

ZV850, ZV855

Hotte Aspirante Îlot

Instructions d’installation

La section française commence à la page 22

Campana de ventilación en isla

Instrucciones de instalación

La sección en español empieza en la página 43

31-10725-1

GE 11/02/09

Safety Information

BEFORE YOU BEGIN

Read these instructions completely and carefully.

• IMPORTANT — Save these instructions for

local inspector’s use.

• IMPORTANT — Observe all governing codes

and ordinances.

• — Note to Installer Be sure to leave these

instructions with the Consumer.

• — Note to Consumer Keep these instructions

with your Owner’s Manual for future reference.

• — Skill Level Installation of this appliance requires

basic mechanical and electrical skills.

• — 1 to 3 Hours.Completion Time

•Proper installation is the responsibility of the installer.

Product failure due to improper installation is not

covered under the warranty.

For Monogram local service in your area, call 1.800.444.1845.

For Monogram service in Canada, call 1.800.561.3344.

For Monogram Parts and Accessories, call 1.800.626.2002.

CAUTION:

Due to the weight and size of these vent hoods and

to reduce the risk of personal injury or damage to the

product, TWO PEOPLE ARE REQUIRED FOR PROPER

INSTALLATION.

WARNING:

To reduce the risk of fire or electrical shock, do not

use this range hood with any external solid-state speed

control device. Any such alteration from original factory

wiring could result in damage to the unit and/or create

an electrical safety hazard.

TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.

WARNING: TO REDUCE THE RISK OF

FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS,

OBSERVE THE FOLLOWING:

A. Use this unit only in the manner intended

by the manufacturer. If you have any questions,

contact the manufacturer.

B. Before servicing or cleaning the unit, switch

the power off at the service panel and lock the

service disconnecting means to prevent the power

from being switched on accidentally. When the

service disconnecting means cannot be locked,

securely fasten a prominent warning device,

such as a tag, to the service panel.

CAUTION: FOR GENERAL VENTILATING

USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS

MATERIALS, EXPLOSIVE MATERIALS OR VAPORS.

WARNING: TO REDUCE THE RISK OF

FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS,

OBSERVE THE FOLLOWING:

•Installation work and electrical wiring must be done

by qualified person(s) in accordance with all applicable

codes and standards, including fire-rated construction.

•Sufficient air is needed for proper combustion

and exhausting of gases through the flue (chimney)

of fuel burning equipment to prevent back-drafting.

Follow the heating equipment manufacturer’s

guidelines and safety standards, such as those

published by the National Fire Protection Association

(NFPA), the American Society for Heating, Refrigeration

and Air Conditioning Engineers (ASHRAE) and the local

code authorities.

•When cutting or drilling into walls or ceilings, do not

damage electrical wiring and other hidden utilities.

•Ducted systems must always be vented

to the outdoors.

•Local codes vary. Installation of electrical connections

and grounding must comply with applicable codes.

In the absence of local codes, the vent should be

installed in accordance with National Electrical Code

ANSI/NFPA 70-1990 or latest edition.

CAUTION: To reduce risk of fire and to

properly exhaust air, be sure to duct air outside—do not

vent exhaust air into spaces within walls or ceilings or

into attics, crawl spaces or garages.

READ AND SAVE THESE INSTRUCTIONS

Design Information

MODELS AVAILABLE

Model ZV850, 360 CFM

Model ZV855, 500 CFM

These hoods may be installed to vent to the outdoors,

or they may be installed for recirculating operation.

All necessary parts for recirculating operation are

supplied with the hood. No kits required.

• These vent hoods can be installed over any 30

”

or 36

”

Monogram electric or gas cooktop except Monogram

Professional cooktops or ranges larger than 30”.

•Reversible duct covers accommodate recirculating

operation.

•The telescopic duct covers conceal the ductwork

running from the top of the hood to the ceiling.

•The supplied duct cover is sized to reach ceiling heights

over 8 feet. See the table on page 8.

PRODUCT DIMENSIONS AND CLEARANCES

The vent hood must be installed 24 minimum and ″

30″maximum above the cooking surface.

NOTE: Installation height should be measured from

the cooking surface to the lowest part of the hood.

ZX8510SPSS Duct Cover Accessory

This accessory is available for installation with ceiling

heights

′

″to over 10 feet.

See the table on page 8.

The duct cover accessory must be on-site with the

hood at the time of installation.

24” Minimum

30” Maximum

36" Minimum

*Height

to Ceiling

8-1/4"

27-1/2”

35-3/8 (excluding utensil rods)ļ

36-1/2 (including utensil rods)ļ

CONTENTS

Design Information

Models Available ................................................................................3

Product Dimensions..........................................................................3

Advance Planning

Ductwork Planning ..........................................................................4

Ceiling Framing for Adequate Support ..................................4

Installation Preparation

Duct Fittings..........................................................................................5

Power Supply ......................................................................................6

Tools and Materials Required ......................................................6

Remove the Packaging ..................................................................7

Check Installation Hardware ......................................................7

Determine Installation Height......................................................8

Install Ceiling Support Structure ........................................9–11

Installation Instructions

Installation – Vented to the Outside ..............................12–16

Step 1, Mount Template ..............................................................12

Step 2, Install Upper Support Frame......................................12

Step 3, Install Lower Support Frame......................................12

Step 4, Secure Wiring ....................................................................13

Step 5, Size and Install Ductwork ............................................13

Step 6, Install Decorative Duct Covers..................................14

Step 7, Install Hood ........................................................................15

Step 8, Connect Electrical............................................................15

Step 9, Slide Duct Cover

Down, Install Side Utensil Rods ................................................15

Step 10, Install Filters ....................................................................16

Step 11, Finalize Installation ......................................................16

Installation Instructions

Installation – Recirculating..................................................17–21

Step 1, Mount Template ..............................................................17

Step 2, Install Upper Support Frame......................................17

Step 3, Install Lower Support Frame......................................18

Step 4, Secure Wiring ....................................................................18

Step 5, Size and Install Ductwork ............................................18

Step 6, Install Decorative Duct Covers..................................19

Step 7, Install Hood ........................................................................20

Step 8, Connect Electrical............................................................20

Step 9, Slide Duct Cover

Down, Install Side Utensil Rods ................................................20

Step 10, Install Filters ....................................................................21

Step 11, Finalize Installation ......................................................21

Product Specifications

Brand:	Monogram
Category:	Extractor hood
Model:	ZV855SPS

Do you need help?

If you need help with Monogram ZV855SPS, ask a question below and other users will answer you

Your Name*

Your Email*

Write your question here

Extractor hood Monogram User Manuals

Monogram ZV750SPSS Manual

13 October 2024

Monogram ZV855SPS Manual

13 October 2024

Monogram ZV830SMSS Manual

13 October 2024

Monogram ZVC48LSS Manual

13 October 2024

Monogram ZV900SLSS Manual

13 October 2024

Monogram ZV36RSFSS Manual

13 October 2024

Monogram ZV800SJSS Manual

13 October 2024

Monogram ZV1050SFSS Manual

13 October 2024

Monogram ZV48TSFSS Manual

13 October 2024

Monogram ZV36TSFS Manual

13 October 2024

Extractor hood User Manuals

Latest Extractor hood User Manuals

27 October 2024

27 October 2024

27 October 2024

27 October 2024

Classique CLRH90GLSS Manual

27 October 2024

Baumatic BRT90SS Manual

27 October 2024

Classique CLRH60BLSS Manual

27 October 2024

Smeg KPFA9AN Manual

27 October 2024

Classique CLRH90LSS Manual

27 October 2024

Baumatic BRC90SS Manual

27 October 2024