Kicker KXMA1500.1 Manual
Read below 📖 the manual in Italian for Kicker KXMA1500.1 (40 pages) in the Receiver category. This guide has been helpful for 4 people and has been rated 4.5 stars on average by 2 users
Page 1/40
KXMA1500.1
Manual del Propietario | Español
AMPLIFICADOR DEL LA SERIE KXM
Benutzerhandbuch | Deutsch
STEREOVERSTÄRKER DER KXM-SERIE
Manuel d’utilisation | Française
AMPLIFICATEUR DE SÉRIE KXM
KXM
AMPLIFIERS
Owner’s Manual
2024 KXMA Mono Amp Rev F.indd 1
2024 KXMA Mono Amp Rev F.indd 1
2024 KXMA Mono Amp Rev F.indd 1
2024 KXMA Mono Amp Rev F.indd 1
2024 KXMA Mono Amp Rev F.indd 1 5/21/2024 11:18:18 AM
5/21/2024 11:18:18 AM
5/21/2024 11:18:18 AM
5/21/2024 11:18:18 AM
5/21/2024 11:18:18 AM
2
KXMA MONO-SERIES AMPLIFIERS
OWNER’S MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no
items behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm)
of open ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger
compartment. Drill four holes using a 7/64” (3mm) bit and use the supplied #8 screws to mount the
amplifi er.
Wiring: The KXMA amplifi er’s RCA inputs will receive either high or low level signals from your car stereo’s
source unit. A high-level signal can be run from the source unit’s speaker outputs to the stereo RCA
input on the end panel of the amplifi er using the KICKER KISL as shown. Alternatively, the signal can be
delivered to the amplifi er using the low-level RCA outputs on the source unit. Keep the audio signal cable
away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it at a
90 degree angle.
PERFORMANCE
MODEL: KXMA1500.1
IMPORTANT SAFETY WARNING
PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER, OR SUBWOOFER IN
A DISTORTED, CLIPPED OR OVER-POWERED MANNER CAN CAUSE YOUR AUDIO SYSTEM
TO OVERHEAT, POSSIBLY CATCHING FIRE AND RESULTING IN SERIOUS DAMAGE TO YOUR
COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO 4 INCHES (10CM) OPEN
VENTILATION. SUBWOOFERS SHOULD BE MOUNTED WITH AT LEAST 1 INCH (2.5CM) CLEARANCE
BETWEEN THE FRONT OF THE SPEAKER AND ANY SURFACE.
Model: KXMA1500.1
RMS Power
@ 14.4V, 4Ω mono, ≤ 1% THD+N
@ 14.4V, 2Ω mono, ≤ 1% THD+N
@ 14.4V, 1Ω mono, ≤ 1% THD+N
750W x 1
1500W x 1
1500W x 1
Length [in, cm] 11-3/16, 28.4
Height [in, cm] 2-1/8, 5.5
Width [in, cm] 8-5/16, 21
Frequency Response [Hz] 10Hz–160Hz
Signal-to-Noise Ratio [dB]
1W Signal-to-Noise Ratio [dB]
>95dB, A-weighted, re: rated power
-75dB
Input Sensitivity Low Level: 125mV–5V
High Level: 250mV–10V
Subsonic Filter 10Hz–80Hz, 24dB/octave (BW)
Selectable Electronic Crossover Variable LP 40–160Hz, 24dB/octave (BW)
KickEQ+™ Bass Boost 0–6dB @ 20Hz–80Hz
Remote Bass Yes (Included)
2024 KXMA Mono Amp Rev F.indd 2
2024 KXMA Mono Amp Rev F.indd 2
2024 KXMA Mono Amp Rev F.indd 2
2024 KXMA Mono Amp Rev F.indd 2
2024 KXMA Mono Amp Rev F.indd 2 5/21/2024 11:18:23 AM
5/21/2024 11:18:23 AM
5/21/2024 11:18:23 AM
5/21/2024 11:18:23 AM
5/21/2024 11:18:23 AM
3
Install a fuse within 7” (18cm) of the battery and in-line with the power cable connected to your amplifi er.
Use only KICKER KMPK Wiring Kits or other genuine KICKER marine accessories when installing
amplifi ers in marine applications.
POWER WIRING
source unit
high-level speaker
outputs
to amplifi er
shield
+
–
core conductor KICKER KISL (optional)
from source unit high-
level speaker outputs
OR
to amplifi er
Model External Fuse Power/Ground Wire(sold separately)
KXMA1500.1 1 x 150 Ampere 1/0 Gauge
+
POWER
GND 12V INPUT OUTPUT
SPEAKER
REM AUTO
TURN-ON
L
R
INPUT LEVEL
12V/DC/AUDIO
REMOTE BASS
LOW/HI/
-
12V
battery
external fuse
remote turn-on (see page 7)
≤7”
(18cm)
ABYC-compliant power terminals Amplifi er uses 304-stainless steel screws
and conformal coated PCB for increased
weather resistance
aluminum bottom plate
2024 KXMA Mono Amp Rev F.indd 3
2024 KXMA Mono Amp Rev F.indd 3
2024 KXMA Mono Amp Rev F.indd 3
2024 KXMA Mono Amp Rev F.indd 3
2024 KXMA Mono Amp Rev F.indd 3 5/21/2024 11:18:23 AM
5/21/2024 11:18:23 AM
5/21/2024 11:18:23 AM
5/21/2024 11:18:23 AM
5/21/2024 11:18:23 AM
Product Specifications
| Brand: | Kicker |
| Category: | Receiver |
| Model: | KXMA1500.1 |
Do you need help?
If you need help with Kicker KXMA1500.1, ask a question below and other users will answer you
Receiver Kicker User Manuals
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
Receiver User Manuals
- Receiver Sony
- Receiver Bosch
- Receiver Brondi
- Receiver Jensen
- Receiver Hartke
- Receiver Goobay
- Receiver Avantree
- Receiver Cayin
- Receiver Axton
- Receiver Kogan
- Receiver Yamaha
- Receiver Extron
- Receiver Lindy
- Receiver Pioneer
- Receiver NuPrime
- Receiver Ecler
- Receiver AudioControl
- Receiver Rotel
- Receiver Toa
- Receiver Marantz
- Receiver Pyle
- Receiver Wet Sounds
- Receiver JVC
- Receiver VMV
- Receiver S.M.S.L
- Receiver Auna
- Receiver OSD Audio
- Receiver Power Dynamics
- Receiver DataVideo
- Receiver Audizio
- Receiver Vonyx
- Receiver Bluesound
- Receiver Blackstar
- Receiver Cambridge
- Receiver MB Quart
- Receiver Aplic
- Receiver CSL
- Receiver NUVO
- Receiver Block
- Receiver Smart-AVI
- Receiver Advance
- Receiver Artsound
- Receiver Denon
- Receiver Yorkville
- Receiver Valcom
- Receiver Mosconi
- Receiver JBL
- Receiver Helix
- Receiver Soundstream
- Receiver Bellari
- Receiver Rolls
- Receiver Ground Zero
- Receiver Karma
- Receiver Glemm
- Receiver EA
- Receiver Match
- Receiver Renkforce
- Receiver Scansonic
- Receiver SPL
- Receiver Audiotec Fischer
- Receiver Crunch
- Receiver A-NeuVideo
- Receiver Classé
- Receiver FoneStar
- Receiver Monitor Audio
- Receiver Peavey
- Receiver Crown
- Receiver Fosi Audio
- Receiver Graupner
- Receiver Antelope Audio
- Receiver Vaddio
- Receiver ESX
- Receiver Omnitronic
- Receiver Russound
- Receiver MEE Audio
- Receiver GigaBlue
- Receiver Mx Onda
- Receiver Black Hydra
- Receiver Electro-Voice
- Receiver Boss
- Receiver JL Audio
- Receiver Shanling
- Receiver Atlas Sound
- Receiver Ashly
- Receiver Audiolab
- Receiver Memphis Audio
- Receiver AVM
- Receiver Primare
- Receiver PureLink
- Receiver Kramer
- Receiver ATen
- Receiver Blustream
- Receiver Yaesu
- Receiver Musical Fidelity
- Receiver RDL
- Receiver Dynacord
- Receiver Ferguson
- Receiver DAP Audio
- Receiver REL Acoustics
- Receiver Inovonics
- Receiver BZBGear
- Receiver Ram Audio
- Receiver Strong
- Receiver Phoenix Gold
- Receiver HiFi ROSE
- Receiver Intelix
- Receiver Comprehensive
- Receiver Deaf Bonce
- Receiver Fiio
- Receiver Lab Gruppen
- Receiver GlobalSat
- Receiver AVMATRIX
- Receiver Koda
- Receiver Technical Pro
- Receiver Marshall Electronics
- Receiver Naim
- Receiver Anthem
- Receiver Audison
- Receiver Hifonics
- Receiver Geemarc
- Receiver Loxjie
- Receiver Clare Controls
- Receiver Edwards Signaling
- Receiver Hegel
- Receiver August
- Receiver PTN-electronics
Latest Receiver User Manuals
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024