Elkay EF1500VRBMC Manual

Elkay Water dispenser EF1500VRBMC

Read below 📖 the manual in Italian for Elkay EF1500VRBMC (8 pages) in the Water dispenser category. This guide has been helpful for 3 people and has been rated 4.5 stars on average by 2 users

Page 1/8
Page 1 1000003634 (Rev. A - 03/17)
IMPORTANT NOTE – To avoid danger of an electric shock hazard, disconnect
power to your unit before installing the îš¿lter.
1500 Gallon Vandal-Resistant Retro-Fit Filter Kit with Filter Monitor
Fig. 1
Installation Manual
EF1500VRBMC
IMPORTANT
THIS IS AN INDOOR APPLICATION ONLY.
ALL SERVICE TO BE PERFORMED BY AN
AUTHORIZED SERVICE PERSON.
TOOLS REQUIRED
BUT NOT PROVIDED:
- SAFETY GLASSES
- GLOVES
- LEVEL
- PENCIL
- MOUNTING SCREWS, ANCHORS, FASTENERS
INSTALLATION STEPS
1. Before starting your installation, verify that
you have the following included pieces.
a. 1 Pinned Torx Bit
b. 2 AA Batteries
c. 1 Pinned Torx Screw
d. 3.5 Feet of Poly Tubing
2. Find a location to mount your new îš¿lter
box near the water dispenser to which it is
being connected. For accurate monitoring,
the îš¿lter box should be mounted vertically
as shown (Fig. 2, page 2).
3. Shut off the water and electricity to the
water dispenser.
4. Lift the cover at the bottom and slide
upwards toward the top.
Page 2
1000003634 (Rev. A - 03/17)
Fig. 2 Fig. 3
Fig. 4
5. Take the îš¿lter box and place on the wall in the desired location. Be sure that the box is
positioned vertically on the wall as shown. The arrow on the water monitor valve should
always be pointing UP (Fig. 4). Make sure the îš¿lter box is level, take a pencil and mark
around the inside opening and the mounting locations. If the water will not be coming thru
the wall into the back of the îš¿lter box, knock-outs have been provided to allow the water lines
to run thru the sides or bottom. If running the water lines thru the knockouts, use the NOTE:
appropriate protection (not provided) to keep the lines from getting cut.
NOTE: All installations must be
compliant with ADA regulations
Page 3 1000003634 (Rev. A - 03/17)
6. Cut a hole in the wall anywhere inside the
marked location to allow room for the water
lines to come into the back of the box.
7. Remove any protective covering from the
outside of the îš¿lter box.
8. Using the appropriate fasteners (Not Supplied),
mount the box to the wall.
Fig. 5
Fig. 6

Product Specifications

Brand: Elkay
Category: Water dispenser
Model: EF1500VRBMC

Do you need help?

If you need help with Elkay EF1500VRBMC, ask a question below and other users will answer you