CRUX SWRGM-48 Manual

Read below šŸ“– the manual in Italian for CRUX SWRGM-48 (6 pages) in the Not categorized category. This guide has been helpful for 4 people and has been rated 4.5 stars on average by 2 users

Page 1/6
Crux Interfacing Solutions ā€¢ Chatsworth, CA 91311
phone: (818) 609-9299 ā€¢ fax: (818) 996-8188 ā€¢ www.cruxinterfacing.com
rev.09282021
1 of 6
RAD IO RE PLAC E ME NT
SWC RE TE NTIO N
+
R
INTERFACING SOLUTIONS
- Retains factory features in select GM Class II Data Bus vehicles while functioning with an aftermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- Voice Recognition Command from factory SWC.
- Supports Bose, non-Bose and Y-91 audio systems.
- Retains chime functions.
- Built-in chime volume adjustment.
- EIA color coded wiring for easy installation.
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
SWRGM-48 MODULE SWRGM-48 HARNESS SWC CABLE
SWRGM-48
Radio Replacement Interface with Steering Wheel Control
Retention for select GM Class II Vehicles
Crux Interfacing Solutions ā€¢ Chatsworth, CA 91311
phone: (818) 609-9299 ā€¢ fax: (818) 996-8188 ā€¢ www.cruxinterfacing.com
SWRGM-48
Radio Replacement Interface with Steering Wheel Control
Retention for select GM Class II Vehicles
2 of 6
RAD IO RE PLAC E ME NT
SWC RE TE NTIO N
+
R
INTERFACING SOLUTIONS
DIP SWITCH SETTINGS:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
RADIO BRAND: DIP#: 1 2 3
Atoto, Dual, Fahrenheit, Jensen, Nakamichi,
Pioneer, Power Acoustik, Soundstream
Blaupunkt, Most oī˜Ÿ-brand Radio
Alpine
Clarion
Kenwood
JVC
Boss, Old Sony
New Sony (with CarPlay)
OFF ON ON
OFF ON ON
OFF ON ON
OFF OFF OFF
ON ON OFF
ON ON ON
ON OFF ON
ON OFF OFF
OFF ON OFF
SWC MODULE
DIP SWITCH
1 2 3
ON
NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Nakamichi, Power Acoustik, Soundstream, and most oī˜Ÿ-brand radios,
check the aftermarket radioā€™s manual to see if the SWC buttons need to be programmed.
4-PIN SWC CABLE
Use the proper 3.5MM to 4-Pin SWC cable for the aīŒermarket radio you are using.
OPTION A is used for ALPINE, CLARION. Use the Blue/Yellow wire for JVC and KENWOOD units.
OPTION B is used for ATOTO, BLAUPUNKT, BOSS, DUAL, FARENHEIT, JENSEN, POWER ACOUSTIK,
PIONEER, SONY, SOUNDSTREAM and Most Oīœ«-Brand Radios.
NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.
SELECTING THE AUDIO SYSTEM:
If the vehicle is equipped with an ampliīšæed audio system,
the SWRGM-48 has a built-in audio level adaptor that
outputs the proper audio level from the aftermarket radio to
the factory ampliīšæer. To use this feature, plug in the male
8-pin connector on the SWRGM-48 harness to the GRAY
female 8-pin connector on the SWRGM-48 module. The
module is also labeled ā€œBoseā€ and ā€œNon Boseā€ to avoid
confusion. (see picture below)
If the vehicle is NOT equipped with a factory ampliīšæed
system, plug in the male 8-pin connector to the BLACK
female 8-pin on the SWRGM-48 module.
BOSE
(Ampliīœ®ed)
ConnecīžŸon
NON BOSE
(Non-Ampliīœ®ed)
ConnecīžŸon
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
For aīŒermarket radios that have wires for SWC connecīžŸons, cut oīœ« the 3.5mm plug on the Crux SWC Cable (opīžŸon B) and
connect the SWC wires as follows:
Note that there are some radios that only have SWC1 and SWC2, in this case ā€œshieldā€ does not need to be connected.
rev.09282021
Crux Interfacing Solutions ā€¢ Chatsworth, CA 91311
phone: (818) 609-9299 ā€¢ fax: (818) 996-8188 ā€¢ www.cruxinterfacing.com
SWRGM-48
Radio Replacement Interface with Steering Wheel Control
Retention for select GM Class II Vehicles
3 of 6
RAD IO RE PLAC E ME NT
SWC RE TE NTIO N
+
R
INTERFACING SOLUTIONS
The SWRGM-48 has a potenīžŸometer to adjust the chime
volume. It is set at half way by default. To adjust the volume,
simply use a suitable screw driver and turn the potenīžŸometer
clockwise to increase the volume and counter-clockwise to
decrease the volume.
Chime
Volume
Adjustment
CHIME VOLUME ADJUSTMENT:
STEERING WHEEL CONTROL BUTTON FUNCTIONS:
SWC Buīž©on SHORT PRESS LONG PRESS
VOL +
VOL -
AM/FM
Preset
NOTES:
Step Increment
Step Decrement
Source
AcīžŸvate VR /
To DeacīžŸvate VR =
on Pioneer, press ā€œPRESETā€
on JVC = say ā€œCancelā€
ConīžŸnuous VOL +
ConīžŸnuous VOL ā€“
Pick Up Call
End Call
To DeacīžŸvate VR =
on Kenwood, long press of PRESET
4 BUTTON SWC
SWC Buīž©on SHORT PRESS LONG PRESS
ALPINE
VOL +
VOL -
Seek Up p
Seek Down q
Source Up
Source Down
Prog
Voice
Step Increment
Step Decrement
Seek Up
Seek Down
Pick up Call
Source
ConīžŸnuous VOL +
ConīžŸnuous VOL ā€“
N/A
N/A
End Call
N/A
4 BUTTON SWC
SWC Buīž©on SHORT PRESS LONG PRESS
CLARION
VOL +
VOL -
Seek Up p
Seek Down q
Source Up
Source Down
Prog
Voice
Step Increment
Step Decrement
Preset Up
Preset Down
Pick up Call
Source
Mute
Mute
ConīžŸnuous VOL +
ConīžŸnuous VOL ā€“
N/A
N/A
End Call
N/A
N/A
N/A
rev.09282021

Product Specifications

Brand: CRUX
Category: Not categorized
Model: SWRGM-48

Do you need help?

If you need help with CRUX SWRGM-48, ask a question below and other users will answer you




Not categorized CRUX User Manuals

CRUX

CRUX SWRFD-60T Manual

19 October 2024
CRUX

CRUX SWRFD-60B Manual

13 October 2024
CRUX

CRUX SOOGM-16K Manual

13 October 2024
CRUX

CRUX SOCGM-17B Manual

13 October 2024
CRUX

CRUX DKGM-49 Manual

13 October 2024
CRUX

CRUX DKGM-C2S Manual

13 October 2024
CRUX

CRUX DKVW-21 Manual

13 October 2024
CRUX

CRUX SOHTL-20 Manual

13 October 2024
CRUX

CRUX AVIGM-04S Manual

13 October 2024
CRUX

CRUX SOCVW-21 Manual

13 October 2024

Not categorized User Manuals

Latest Not categorized User Manuals