Mosconi Gladen Pro 5/30 Manual
Read below 📖 the manual in Italian for Mosconi Gladen Pro 5/30 (1 pages) in the Receiver category. This guide has been helpful for 13 people and has been rated 4.5 stars on average by 2 users
Page 1/1
PRO 5|30
4-channel AB class / 1-channel D amplifier [ Rev. 3.0 – 2017/10 ]
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
CEA-2006-A SPECIFICATIONS
POWER RATING :(@ 4 Ohm < 1% THD+N) 70Wx2 + 150Wx2 + 550Wx1
SN RATIO :(ref.: 1 Watt into 4 Ohm) >75 dBA (CH1/2) >71 (CH3/4) >73 (CH5)
SN RATIO Direct DSP :(ref.: 1 Watt into 4 Ohm) >83 dBA (CH1/2) >76 (CH3/4) >76 (CH5)
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
MOS SPECIFICATIONS (Tcase = 25 °C / 4 Ohm stereo / 0.2V input level @ 14.4 Volt if not otherwise specified)
TARGET POWER: 85x2 Watt (CH1/2), Watt (CH3/4), Watt (CH5) [@ 4 Ohm]170x2 600x1
REAL POWER ( ):
single section driven CH1/2: W W 95x2 @ 4 Ohm / 150 x2 @ 2 Ohm
1% THD [CH1/2/3/4] – 3% THD [CH5] CH3/4: W W 185x2 @ 4 Ohm / 290 x2 @ 2 Ohm
CH5: W W 660 @ 4 Ohm / 1030 @ 2 Ohm
REAL POWER ( ):
all sections driven 70x2 W (CH1/2) + W (CH3/4) + W (CH5)150x2 @ 4 Ohm 550x1 @ 4 Ohm
1% THD [CH1/2/3/4] – 3% THD [CH5] 65x2 W (CH1/2) + W (CH3/4) + W (CH5)135x2 @ 4 Ohm 760x1 @ 2 Ohm
W (CH1/2) + W (CH3/4) + W (CH5)85x2 195x2 @ 2 Ohm 750x1 @ 2 Ohm
Watt ( )1310 is the total amount of power the amplifier can deliver
THD (90% power rating ref.)
4 Ohm / ST mode < 0.045 % < 0.035 % < 1 % (CH1/2 - 1KHz) (CH3/4 - 1KHz) (CH5 - 100Hz)
2 Ohm / ST mode:< 0.05 % < 0.04 % < 1 % (CH1/2 - 1KHz) (CH3/4 - 1KHz) (CH5 - 100Hz)
DC-DC converter typology / Conversion frequency: Unregulated Push-Pull / 50 Khz (managed by microcontroller)
Supply voltage range operation: 9 V ÷ 16 V 11 V ÷ 14.4 V (Absolute maximum) / (Recommended)
Under / Over Voltage Safety Thresholds: 8 V 16 V(1 sec. 6V sustaining for Start & Stop) /
Mute delay time: 4 secs.
Secondary voltages (VDD#12 /VDD#34 /VDD#5 / DRIVE / SERV): ±33.1 V / ±45.3 V / ±84.7 V / ±14 V / ±15 V
Max output offset voltage (each channel): ±15 mV
Standby current: < 1 mA (typical)
Quiescent consumption @ 12V6 / 14V4: 1.90 A / 2.15 A (no idle current regutation)
Idle current regulation (no signal): 0.05 A (each trimmer)
Quiescent consumption @ 14V4: 2.25 A (with idle current setted)
Thermal protection consumption: 140 mA
Ground decoupling: (RCA Input) / 47R 1 KOhm (battery vs secondary) / (body vs battery)68 Ohm
Bandwidth (-3dB ÷ 1 Watt): < 5 Hz ÷ 135 KHz < 5 Hz ÷ 145 KHz < 5 Hz ÷ 1.75 KHz (CH1/2); (CH3/4); (CH5 10Watt)
Input sensitivity (Power rating ref): 0.35 V ÷ 12 V (5.3 V in DDSP mode) (3.1 V in DDSP mode) [CH1/2/3/4] 0.14 V ÷ 5.9 V [CH5]
Input impedance @ 1 KHz (STEREO input): 15 KOhm / 47 Ohm (LL) (HL)
S/N ratio – Power rating ref: (filter: 10 Hz - 500 KHz ) / (filter: 10 Hz - 22 KHz “A” weighted) 67 dB 94 dB
S/N ratio DDSP – Power rating ref: (filter: 10 Hz - 500 KHz ) / (filter: 10 Hz - 22 KHz “A” weighted) 69 dB 100 dB
Channel separation@ 100Hz / 1KHz / 10KHz – 10 Watt ref: 75 dB / 75 dB / 62 dB
Xover functions (selectable filters): CH1/2= HP: 43 ÷ 500Hz(x1) or 430 ÷ 5000Hz(x10) [12 dB/oct – Q: 0.7]
CH3/4= HP: 50 ÷ 200Hz & LP:(430 ÷ 5000Hz) [12 dB/oct – Q: 0.7]
CH5= LP: 43 ÷ 200Hz [24 dB/oct]
Special features: DDSP - Direct DSP (bypass all the preamplifier circuitry but the differential input interface)
HL/LL - High Level / Low Level selectable input
Controlled via uC – Internally controlled via Atmel Processor
Thermal cutoff Threshold: 90°C / 100°C (CH5 cutoff) (Overall cutoff) / (resume to normal operation)70°C
ProSPEED® Fan Controller Threshold: 50°C / 45°C / 70°C (start) (stop) (max speed)
Damping factor @ 100 Hz 10 Watt ref (Right / Left):- 319/397 318/487 153 [CH1/2] - [CH3/4] - [CH5]
Damping factor @ 1 KHz 10 Watt ref (Right / Left):- 291/375 304/453 101 [CH1/2] - [CH3/4] - [CH5]
Damping factor @ 10 KHz 10 Watt ref (Right / Left): - 178/199 183/219 n.a. [CH1/2] - [CH3/4] - [CH5]
Load drive limitations (*): 2 Ohm / 4 Ohm (Stereo / Bridged)
Suggested fuse: 150 A (Internal)
Size (mm): 500 / 205 / 55
Weight (Kg): 5.4
(*) VERY IMPORTANT NOTE - READ CAREFULLY
4 Ohm ST 8 Ohm BTL or – CONTINUOUS SINEWAVE SIGNAL – pure resistive load or speaker load
2 Ohm ST 4 Ohm BTL or – – pure resistive load or speaker loadMUSICAL SIGNAL
2 Ohm – – pure resistive load or speaker load (only CH5)MUSICAL SIGNAL
All Right Reserved - Features may change without notice -
Product Specifications
| Brand: | Mosconi |
| Category: | Receiver |
| Model: | Gladen Pro 5/30 |
Do you need help?
If you need help with Mosconi Gladen Pro 5/30, ask a question below and other users will answer you
Receiver Mosconi User Manuals
13 October 2024
13 October 2024
13 October 2024
13 October 2024
13 October 2024
13 October 2024
13 October 2024
13 October 2024
13 October 2024
13 October 2024
Receiver User Manuals
- Receiver Sony
- Receiver Bosch
- Receiver Brondi
- Receiver Jensen
- Receiver Hartke
- Receiver Goobay
- Receiver Avantree
- Receiver Cayin
- Receiver Axton
- Receiver Kogan
- Receiver Yamaha
- Receiver Extron
- Receiver Lindy
- Receiver Pioneer
- Receiver NuPrime
- Receiver Ecler
- Receiver AudioControl
- Receiver Rotel
- Receiver Toa
- Receiver Marantz
- Receiver Pyle
- Receiver Wet Sounds
- Receiver JVC
- Receiver VMV
- Receiver S.M.S.L
- Receiver Kicker
- Receiver Auna
- Receiver OSD Audio
- Receiver Power Dynamics
- Receiver DataVideo
- Receiver Audizio
- Receiver Vonyx
- Receiver Bluesound
- Receiver Blackstar
- Receiver Cambridge
- Receiver MB Quart
- Receiver Aplic
- Receiver CSL
- Receiver NUVO
- Receiver Block
- Receiver Smart-AVI
- Receiver Advance
- Receiver Artsound
- Receiver Denon
- Receiver Yorkville
- Receiver Valcom
- Receiver JBL
- Receiver Helix
- Receiver Soundstream
- Receiver Bellari
- Receiver Rolls
- Receiver Ground Zero
- Receiver Karma
- Receiver Glemm
- Receiver EA
- Receiver Match
- Receiver Renkforce
- Receiver Scansonic
- Receiver SPL
- Receiver Audiotec Fischer
- Receiver Crunch
- Receiver A-NeuVideo
- Receiver Classé
- Receiver FoneStar
- Receiver Monitor Audio
- Receiver Peavey
- Receiver Crown
- Receiver Fosi Audio
- Receiver Graupner
- Receiver Antelope Audio
- Receiver Vaddio
- Receiver ESX
- Receiver Omnitronic
- Receiver Russound
- Receiver MEE Audio
- Receiver GigaBlue
- Receiver Mx Onda
- Receiver Black Hydra
- Receiver Electro-Voice
- Receiver Boss
- Receiver JL Audio
- Receiver Shanling
- Receiver Atlas Sound
- Receiver Ashly
- Receiver Audiolab
- Receiver Memphis Audio
- Receiver AVM
- Receiver Primare
- Receiver PureLink
- Receiver Kramer
- Receiver ATen
- Receiver Blustream
- Receiver Yaesu
- Receiver Musical Fidelity
- Receiver RDL
- Receiver Dynacord
- Receiver Ferguson
- Receiver DAP Audio
- Receiver REL Acoustics
- Receiver Inovonics
- Receiver BZBGear
- Receiver Ram Audio
- Receiver Strong
- Receiver Phoenix Gold
- Receiver HiFi ROSE
- Receiver Intelix
- Receiver Comprehensive
- Receiver Deaf Bonce
- Receiver Fiio
- Receiver Lab Gruppen
- Receiver GlobalSat
- Receiver AVMATRIX
- Receiver Koda
- Receiver Technical Pro
- Receiver Marshall Electronics
- Receiver Naim
- Receiver Anthem
- Receiver Audison
- Receiver Hifonics
- Receiver Geemarc
- Receiver Loxjie
- Receiver Clare Controls
- Receiver Edwards Signaling
- Receiver Hegel
- Receiver August
- Receiver PTN-electronics
Latest Receiver User Manuals
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024